CONTACT US

Our Address

Science Avenue, High-tech Zone, Zhengzhou City, Henan Province, China

  • How to Melt Gold Out of Rocks Sciencing

    The process of extracting gold from ore is a multistep one, and historically it has involved the use of some dangerous chemicals, including cyanide and mercury. Cutting-edge extraction techniques have eliminated the need for these chemicals and made the process much safer. It's still too dangerous to try at home, though. Crushing the Rock. Rocks that contain visible gold veins usually have ...

  • How to Use Bleach on Gold Ore to Remove Gold Sciencing

    Bleach is the chemical compound sodium hypochlorite. When combined with hydrochloric acid, the mixture produces chlorine that dissolves gold from gold ore. This was the first commercial method used for gold extraction. Place the ore into the mortar and grind it to the size of sand grains. Put the ore grains into a plastic bowl. Add the 35-percent hydrochloric acid to the sodium hypochlorite ...

  • Rock Crushing methods and How to recover gold from Ores

    (Selling your gold) Some specimens however, especially those with a large amount of rock and only a limited amount of gold are best crushed and the gold extracted and sold to refiner (information about selling to refiners can also be found on my gold selling page). Here is a discussion of the procedures to crush Quartz or other minerals and extract the gold from these rich ores.

  • how to crush ore for silver and gold without chemicals

    Testing Ores for Free Gold - ICMJ's Prospecting and Mining Journal . I get a number of questions from people about testing and treating hard rock ores. The simplest way, but also an expensive one, is to just have an assay test done by ...

  • 9.2/10(8)
  • Recovering Silver from Crushed Ore? - Gold Refining

    08/05/2016  Without knowing a great deal about the ore in question, you're not likely to get much useful advice here. Extracting gold and silver from ores isn't a cut and dried process---there are many ways to achieve the end, each dependent on the type of ore. Frankly, unless your ore (fire) assays at least a few ounces of gold per ton, you can spin your wheels endlessly and never make a dime. Large ...

  • Crushing Ore to Recover Gold - YouTube

    11/06/2012  Crushing a small ore sample to recover the gold buried inside. This sample was found in a lode vein in Marion County, Oregon. The ore is heavily laden with copper and pyrite along side of quartz.

  • Chemical tests for the metal content of various ores

    If at all purple, gold is present in the ore, and the relative amount may be approximately deduced. This method takes little time, and is trustworthy." Copper: Copper is a very easy mineral to test for. First crush the ore and dissolve it in nitric acid by heating. Then dilute with some water, and add ammonia. The solution should turn dark blue ...

  • How do i separate gold from sulphides without using ...

    Look-up Iodine leaching of Gold on the internet. Iodine is safe and reusable. Also it leaches Gold,Platinum, and silver in that order and none of the base metals. Works great on iron gossan which is what you have in your dirt.That's really a good thing because you don't have the cost to crush your ore. JackWayne Http://www ...

  • Gold Ore Processing Plant, Crushing Quartz Hardrock Gold ...

    15/01/2019  This is a video showcasing our 1 ton per hour complete, chemical free, gold ore gravity processing plant. This system is specifically designed for the small to medium scale miner. It is ideal for ...

  • Crushing Ore for Gold Veins - Hardrock Lode Mining - Rock ...

    An alternative to an assay test is to determine just the free gold content found on the ore. Free gold is the portion that is easily removed without the use of complex chemical procedures. Miners have been extracting free gold from hard rock sources for thousands of years. It simply requires that the ore be crushed and broken apart enough that ...

  • URBAN MINING! Recovering gold, copper, precious metals ...

    13/12/2014  This would be considered very high grade gold ore for any miner. The PCB's also have loads of copper, tin, lead, plated gold, etc that is added value on top of that 1 oz/ton free gold recovered.

  • How to Refine Gold With Nitric Acid Sciencing

    Whether it's freshly mined gold ore or refined gold used in jewelry, contaminants, unwanted minerals and other metals are usually present. Gold rings, chains and necklaces are often alloys of gold mixed with a percentage of silver, rather than being gold alone. While various procedures can purify gold, using substances like saltpeter or concrete, today nitric acid combined with hydrochloric ...

  • Rcovery of gold in pyritic ores - Mine Engineer.Com

    However, if the ore is ground to -200 mesh, most times, a few specs of gold can be visibly seen under microscopic examination. Based upon numerous case studies, it appears that gold particles in pyrite are generally fine, ranging from 75 microns down to 2 or 3 microns. The incidence of fine gold's quantity also appears to be related to the gold concentration, as well. If the assay is 2 ounces ...

  • Gold recovery from chips, Learn Gold recovery from chips

    Since obtaining gold from chips is a very profitable business, a lot of people all over the world are interested in starting this business either on a small or large scale. These days there are numerous videos on the net telling people how to get gold from chips. But they forget one thing that the use of chemicals without proper guidance can also be hazardous. I am not trying to scare anybody ...

  • Gold Processing Methods Gold Ore Extraction

    The feed gold and silver was amenable to gravity separation and flotation. However, the subsequent cyanidation of the concentrates did not provide any significant improvement, on average, over Whole-of-Ore CIL testing. The gravity/flotation flowsheet with cyanidation of the respective concentrates recovered between 30 and 77% of the gold in feed, with an average of about 59 percent across all ...

  • Fine Gold Recovery. Separating Placer Gold Particles from ...

    Separating fine gold particles from black sands is one of the biggest challenges that gold prospectors have to deal with. This article will describe a simple and inexpensive method of capturing fine gold. Most small scale prospectors do not need to invest thousands of dollars to capture small placer gold dust. Using fine gold recovery methods, you can retain the vast majority of gold in your ...

  • How to Make 24K Gold Sciencing

    How to Use Bleach on Gold Ore to Remove Gold. Updated April 24, 2017 . By Michael Rytting. 24K gold is the highest purity of gold commercially sold. It has numerous industrial and investment uses, but the term 24K gold is most commonly associated with jewelry. Because gold is an element, it cannot really be made. However, gold can be refined to the 24K level. Gold found in nature, scrap gold ...

  • Electronics Recycling- Rich Source of Precious Metals

    10/10/2019  This e-waste is a particularly rich source of precious metals—with concentrations 40 to 50 times more abundant than naturally occurring in ore deposits. There are over 320 tons of gold and greater than 7,500 tons of silver used each year to make new electronic products around the world.

  • Recovery of Gold, Silver, Palladium, and Copper from Waste ...

    Gold 0.039 Silver 0.156 Palladium 0.009 Copper 18.448 Other metals 9.35 Non-metals 72 Gold, silver, copper, and palladium contributed to more than 91% of the total worth of metals found in PCBs, and thus these four metals were selected for further study. The total value of these metals added up to $24.3 per kg of PCB. II. METAL RECOVERY PROCESS

  • PARTING: Separate Gold and Silver by Melting

    The gold thus obtained is usually of a fineness of about 997 or 998, the remainder being chiefly silver, which would not pay for extraction although part of it could be separated with a further expenditure of time, fuel, and acid. The gold is pressed by a hydraulic ram, the pressure exerted being about 800 lbs. to the square inch. The cakes of metal are dried at a cherry-red heat, and then ...

  • PARTING: Separate Gold and Silver by Melting

    The gold thus obtained is usually of a fineness of about 997 or 998, the remainder being chiefly silver, which would not pay for extraction although part of it could be separated with a further expenditure of time, fuel, and acid. The gold is pressed by a hydraulic ram, the pressure exerted being about 800 lbs. to the square inch. The cakes of metal are dried at a cherry-red heat, and then ...

  • Fine Gold Recovery. Separating Placer Gold Particles from ...

    Separating fine gold particles from black sands is one of the biggest challenges that gold prospectors have to deal with. This article will describe a simple and inexpensive method of capturing fine gold. Most small scale prospectors do not need to invest thousands of dollars to capture small placer gold dust. Using fine gold recovery methods, you can retain the vast majority of gold in your ...

  • Electronics Recycling- Rich Source of Precious Metals

    10/10/2019  This e-waste is a particularly rich source of precious metals—with concentrations 40 to 50 times more abundant than naturally occurring in ore deposits. There are over 320 tons of gold and greater than 7,500 tons of silver used each year to make new electronic products around the world.

  • Recovery of Gold, Silver, Palladium, and Copper from Waste ...

    Gold 0.039 Silver 0.156 Palladium 0.009 Copper 18.448 Other metals 9.35 Non-metals 72 Gold, silver, copper, and palladium contributed to more than 91% of the total worth of metals found in PCBs, and thus these four metals were selected for further study. The total value of these metals added up to $24.3 per kg of PCB. II. METAL RECOVERY PROCESS

  • Extracting gold from rock - OpenLearn - Open University

    That way, we can crush the rock without losing any of the precious gold particles. We also need a special kind of hammer, which fits into the container without leaving too much room for the rock to escape. Rather than use a conventional hammer, we used pulleys and a rope to raise and drop a heavy weight. Pulleys increase the length of rope that needs to be pulled in order to raise the heavy ...

  • Extracting Gold HowStuffWorks

    Leaching dissolves the gold out of the ore using a chemical solvent. The most common solvent is cyanide, which must be combined with oxygen in a process known as carbon-in-pulp. As the cyanide and oxygen react chemically, gold in the pulp dissolves. When workers introduce small carbon grains to the tank, the gold adheres to the carbon. Filtering the pulp through screens separates the gold ...

  • Gold and Platinum Refining Recovery Systems / Equipment

    An overview on how to refine precious metals. There are many kinds of materials that yield pure gold, platinum, or silver when refined. Though it's usually a little intimidating the first time you do anything, refining precious metals yourself is relatively easy to do (even with no experience) provided you have the right information, supplies, and equipment.

  • Cornstarch Replaces Cyanide In Gold Extraction Popular ...

    14/05/2013  Gold, precious forever but especially lately, is a tricky metal. Bound up in consumer electronics, jewelry and the ores that it comes from, gold is

  • Extracting Gold from Rock - PBS: Public Broadcasting Service

    Extracting Gold from Rock by Mike Leahy ... With those tools we could crush the rock without losing any of the precious gold particles. We also needed a special kind of hammer - one that would fit ...

  • Gold Smelting at Home - Mineral Processing Metallurgy

    In smelting and melting for pure gold, that is, gold of 24-kt. value is very much too soft for jewelry purposes and it is therefore always alloyed with other metals to increase its hardness and resistance to wear. For the same reason pure silver is seldom used alone but is alloyed with copper, the standard alloy being sterling silver which contains 92.5% silver and 7.5 % copper. The metals ...

  • Gold and Platinum Refining Recovery Systems / Equipment

    An overview on how to refine precious metals. There are many kinds of materials that yield pure gold, platinum, or silver when refined. Though it's usually a little intimidating the first time you do anything, refining precious metals yourself is relatively easy to do (even with no experience) provided you have the right information, supplies, and equipment.

  • Cornstarch Replaces Cyanide In Gold Extraction Popular ...

    14/05/2013  Gold, precious forever but especially lately, is a tricky metal. Bound up in consumer electronics, jewelry and the ores that it comes from, gold is

  • Extracting Gold from Rock - PBS: Public Broadcasting Service

    Extracting Gold from Rock by Mike Leahy ... With those tools we could crush the rock without losing any of the precious gold particles. We also needed a special kind of hammer - one that would fit ...

  • How to Take the Impurities out of Gold LEAFtv

    Gold ore, when discovered in nature, is usually found combined with stones and other metals, such as silver and lead. This natural state does not display gold's aesthetic virtues, nor does it easily permit workers in gold to fashion jewelry. Gold refiners use several different methods to remove these impurities and achieve a high level of purity in the final product. Removing impurities ...

  • How to Test Ore or Rock for Gold Content

    It is advisable first of all to examine the ore for visible gold and silver, the presence of which might influence the choice of a method of treatment. If no gold or native silver can be seen in the rock, take a representative sample of about 300 grams and grind it up to pass a No. 30 sieve. Weigh out 250 grams and carefully pan down until most of the gangue is removed. Examine the heavy ...

  • Mining Technology in the Nineteenth Century ONE

    They sometimes used mercury, which forms an amalgam with small particles of gold and silver. Miners used mechanical crushing and grinding machines to break up ores for further processing. Early miners used Mexican arrastras or stamp mills, which reached their peak in the late nineteenth century, to crush ores into sand-size particles. Before going to stamp mills, ores often went through rock ...

  • How to reform solid gold after dissolving it in aqua regia ...

    There are many ways to do that. You can add more HCl and boil off any NO2, then dilute and add a good reducing agent. Hydrazine is a good one, because it leaves no traces (it forms nitrogen). The gold precipitates in a spongy form; it looks a bit ...

  • How to Test Gold With Vinegar Our Pastimes

    If you've ever wondered whether a gold piece is real gold or some other type of metal, you can find out without taking it to a jeweler or pawn shop. Using equipment and ingredients you already have, you can test the authenticity of gold with a very simple test conducted in your own kitchen.

  • 6 Ways to Test Silver - wikiHow

    02/03/2020  Silver is a versatile chemical element. Sterling silver is 92.5 percent silver and 7.5 percent other metals, primarily copper. It is harder than pure silver. Pure silver is soft and often called "fine silver." Products often can be mistaken as silver if they are silver plated (merely covered with a thin layer of fine silver). Scroll down to Step 1 to begin testing your silver. Steps. Method 1 ...

  • Crusher - Wikipedia

    A crusher is a machine designed to reduce large rocks into smaller rocks, gravel, sand or rock dust.. Crushers may be used to reduce the size, or change the form, of waste materials so they can be more easily disposed of or recycled, or to reduce the size of a solid mix of raw materials (as in rock ore), so that pieces of different composition can be differentiated.